Juniper Networks M120 Instrukcja Użytkownika Pobierz pdf (Strona 91)

SONET/SDH OC12c/STM4 PIC

■

JUNOS 8.0R2 and later

NOTE: This PIC is not supported in JUNOS Release 8.1R1.

Software release

■

One OC12 port

■

Power requirement: 0.23 A @ 48 V (10.8 W)

Description

■

Multiplexing and demultiplexing

■

Rate policing on input

■

Rate shaping on output

■

Packet buffering, Layer 2 parsing

Hardware features

■

SONET/SDH framing

■

Link aggregation

■

Alarm and event counting and detection

■

Dual-router automatic protection switching (APS)

■

Multiprotocol Label Switching (MPLS) fast reroute

■

Encapsulations:

■

High-Level Data Link Control (HDLC)

■

Frame Relay

■

Circuit cross-connect (CCC)

■

Translational cross-connect (TCC)

■

Point-to-Point Protocol (PPP)

Software features

■

Duplex SC/PC connector (Rx and Tx)

■

Optical interface support—See Table 28 on page 93

NOTE: To extend the life of the laser, when a PIC is not being actively used with any valid

links, take the PIC offline until you are ready to establish a link to another device. For

information about taking a PIC offline, see the request chassis pic offline command in the

JUNOS System Basics and Services Command Reference.

Cables and connectors

SONET/SDH OC12c/STM4 PIC ■ 91

SONET/SDH OC12c/STM4 PIC

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 115 116

Komentarze do niniejszej Instrukcji

Brak uwag

Juniper Networks M120 Instrukcja Użytkownika Strona 91

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Networking Juniper Networks M120