Juniper Networks 200 Series Instrukcja Użytkownika Strona 32
- Strona / 40
- Spis treści
- BOOKMARKI
Oceniono. / 5. Na podstawie oceny klientów
Chapter 3 Configuring the Device
26 User’s Guide
5. (Optional) By default, the console times out and terminates automatically after
10 minutes of idle time. To change this timeout interval, execute the following
command:
set console timeout number
where number is the length of idle time in minutes before session termination.
To prevent any automatic termination, specify a value of 0.
Starting a Console Session Using Dialup
Each NetScreen-200 Series device provides a modem port that allows you to establish a
remote console session using a dialup connection through a 9600 bps modem cabled to the
modem port. Dialing into the modem establishes a dialup console connection.
Establishing a GUI Management Session
To access the NetScreen-200 Series device with the WebUI management application:
1. Connect your computer (or your LAN hub) to the ethernet1 port using a
Category-5 Ethernet cable.
2. Launch your browser, enter the IP address of the ethernet1 interface in the
URL field, and then press Enter.
For example, if you assigned the ethernet1 interface an IP address of
10.100.2.183/16, enter the following:
10.100.2.183
The NetScreen WebUI software displays the login prompt.
3. Enter netscreen in both the Admin Name and Password fields, then click
Login. (Use lowercase letters only. The Admin Name and Password fields are
both case sensitive.)
Note: The Terminal type for dialup sessions must be vt100. For example, in Hilgreave
HyperTerminal (a commonly-used terminal application), select Connect >> Remote
System, then select vt100 from the Term Type menu.
- NETSCREEN-200 SERIES 1
- Copyright Notice 2
- FCC Statement 2
- Disclaimer 2
- Contents 3
- GUIDE ORGANIZATION 5
- Overview 7
- NETSCREEN-200 SYSTEMS 8
- THE FRONT PANEL 9
- Asset Recovery Pinhole 10
- Console and Modem Ports 11
- Compact Flash Card Slot 11
- THE REAR PANEL 12
- Power Fuse 13
- Chapter 1 Overview 14
- 8 User’s Guide 14
- Installing the Device 15
- CONNECTING THE POWER 17
- WIRING A DC POWER SUPPLY 18
- 14 User’s Guide 20
- Configuring the Device 21
- OPERATIONAL MODES 22
- Connectivity Examples 24
- Performing Device Connection 25
- Device 1 Device 2 26
- Device 1 27
- Device 2 27
- Switches 28
- Allowing Outbound Traffic 31
- 10.100.2.183 32
- ASSET RECOVERY 34
- 30 User’s Guide 36
- Specifications 37
- 0 - 12,000 ft. (0 - 3,660 m) 38
- Non-condensing 10-90% 5-95% 38
- NetScreen-200 Series IX-I 39
- IX-II User’s Guide 40
Powiązane produkty i podręczniki dla Networking Juniper Networks 200 Series
(284 strony)Energenie Chargeurs de batterie manuels d'utilisation
À partir de E
Komentarze do niniejszej Instrukcji