Juniper Networks EX3200 Instrukcja Użytkownika Pobierz pdf (Strona 187)

Chapter 12

Performing Initial Configuration

■ Connecting and Configuring an EX Series Switch (CLI Procedure) on page 161

■ Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 163

■ Configuring the LCD Panel Display on EX Series Switches (CLI

Procedure) on page 166

■ Setting the Mode on an SFP+ Uplink Module (CLI Procedure) on page 168

Connecting and Configuring an EX Series Switch (CLI Procedure)

There are two ways to connect and configure an EX Series switch: one method is

through the console using the CLI and the other is using the J-Web interface. This

topic describes the CLI procedure.

Before you begin connecting and configuring an EX Series switch through the console

using the CLI:

■ Set the following parameter values in the console server or PC:

■ Baud Rate—9600

■ Flow Control—None

■ Data—8

■ Parity—None

■ Stop Bits—1

■ DCD State—Disregard

■

To run the ezsetup script, the switch must have the factory default configuration.

If you have configured anything on the switch and want to run ezsetup, revert

to the factory default configuration. See Reverting to the Default Factory

Configuration for the EX Series Switch.

Connecting and Configuring an EX Series Switch (CLI Procedure) ■ 161

1 2 ... 182 183 184 185 186 187 188 189 190 191 192 ... 283 284

Brak uwag

Juniper Networks EX3200 Instrukcja Użytkownika Strona 187