Juniper-networks J4350 Instrukcja Użytkownika Strona 191

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 284
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 190
Replacing and Troubleshooting Hardware Components
Figure 54: Attaching Air Filter and Filter Cover
g003819
POWER
POW
ER
STAT U S
ALARM
HA
RESET
CONFIG
PORT 0
STATUS
Air filter
Filter cover
Cover latches
We recomme
nd changing the f ilter every 6 months. However, the optimal filter
replacement interval can vary depending on the environment where the router
is located. If temperature alarms appear, inspect the air filter.
To replace the air filter:
1. Remove the filter cover by squeezing the plastic tabs on e ither side of the
filter co
ver.
2. Pull the filter cover away from the chassis.
3. Remove the old filter.
4. Place the
new filter in the opening.
5. Replace the filter cover by pressing it u ntil it clicks into place.
Troubleshooting Hardware Components
This section provides an overview of the resources you can use to troubleshoot
hardware
problems on the Services Router:
Chassis Alarm Con d iti ons on page 171
Contacting the Juniper Networks Technical Assistance Center on page 173
Chassis
Alarm Conditions
When the
Routing Engine detects an alarm condi tio n, it lights the
ALARM LED on
the front panel. Wh en the condition is corrected, the light turns off.
Troubleshooting Hardware Components 171
Przeglądanie stron 190
1 2 ... 186 187 188 189 190 191 192 193 194 195 196 ... 283 284

Komentarze do niniejszej Instrukcji

Brak uwag